First find your brand name of the router (company name).Note: Again I am sorry I can't directly help you in this area there are far too many different routers out there that have different ways of opening ports.Įventhough I can't give direct steps, I can say this:.Don't worry, your settings should be saved so all you would have to do next time is reclick the bullets to make them static again! All you need to do is click the bullets that say "Obtain an IP address automatically" as well as "Obtain DNS server address automatically". WIRELESS USERS: This is where you would change back the settings to dynamic when you are on another wireless network than your home (or wherever your main internet you use is located).Also I think that defaultly, the "DNS servers" in the Command Prompt might be right under the "Subnet Mask" and not by itself like you see in mine.By default the DNS settings should be the same as "Default Gateway" and usually you will not have a "Alternate DNS" address and it can be left blank if you don't see it in the Command Prompt. NOTE: My DNS settings will probably be different from what you will see.My only explaination is that the firewall chooses how to open the ports defaultly that work or don't work)įirst select the bullet that says "Use the following IP address:" as well select the bullet that says "Use the following DNS server addresses:" then bring back up the Command Prompt (cmd) we minimized earlier and copy the information as shown in the picture below (Sorry that I can't explain exact reasons to why sometimes you need to while other times you don't. However often you will need to manually open the port because it is just not going to work without doing so. For example, when I opened the required port for this game, I did not even need to touch my firewall as it had default settings that apparently I did not even need to change/alter to host a server. Actually depending on the situation, this step might not even be needed.What Makes Opening Ports for my Firewall Nessasary? Unless you need a static IP (like in this case: hosting a server), there is no reason to have one. By default, Windows sets your local IP automatically (aka dynamically) because as more people get onto your local network, this will keep you and another person obtaining the same local IP which would cause ip conflictions (or unable to connect to the network as a whole).Why are local static IP's not set by default? If your local ip changes, the forwarded ports are not going to apply to your computer anymore and you will occasionally have to change them. When you set your router's settings, you will have to state what the local IP the forwarded ports are going to be allowed to. For varying reasons, your IP might change if not set as a static IP.If you don't care then just skip this section. This section is just for people questioning why they need to do this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |